Transmission adapter
Hello,
It’s been a while once again.
Were are currently doing great with the Formula SAE Hybrid project. I am learning a lot on different aspect of EV .
Since this week was spring break, I had some spare time to work on the VEON.
I did the motor to transmission adapter using a 1” nipple and a 1” circular adapter. Both intern diameter fit perfectly with the motor shaft.
The only thing left is to do a male 1/4” thread to insert a 1/4” diameter screw to secure the adapter to the shaft.
Here a picture of the adapter so far
Enjoy…
EDIT : this part will be custom made later on. it is not strong enough … but it is still nice for a <5$ part !!! It gives me a good idea of the part.
Advertisement
